1. Remote control of the fire control headquarters: When a fire occurs, the infrared detector delivers a fire signal to the fire control headquarters. The staff on duty manually selects and starts the corresponding fire cannon, and displays the video image of the gun position camera on the display of the main control console. On the screen, the control handle of the control gun searches and locates and locks the ignition source. Press the start button to start the water pump and electric valve. The fire cannon sprays out the fire. The ignition source goes out and the initial state is restored. During the entire search, positioning and fire extinguishing process, the video recorder automatically performs full-time real-time video recording.
2. On-site emergency electrical control: When the on-site fire attendant finds the fire and decides that it is not appropriate to extinguish the fire by conventional methods (fire hydrant, fire extinguisher, etc.), the fire attendant can directly open the door of the fire control box near the scene and remove it. Manual control box, press the "manual alarm" button or press any control button to generate an alarm signal. The fire gun system information processing host automatically starts the fire gun power supply corresponding to the geographical location, and simultaneously sends a fire alarm signal and the address of the ignition source to the fire automatic alarm system host through the communication interface, and the fire automatic alarm system host issues a fire alarm and performs Corresponding linkage operation. The firefighters at the scene manipulated the buttons in the hand control box to point the muzzle at the source of the fire, and pressed the start button to start the water pump and electric valve. While operating at the scene, the gun position camera displays the video image of the scene on the display screen of the main control console. During the entire search, positioning and fire extinguishing process, the video recorder automatically performs full-time real-time video recording.
3. Automatic control by fire control department: When the infrared detector detects a fire, it sends an alarm signal to the system information processing host. The information processing host sends an alarm signal to the automatic fire alarm system through the communication RS485 interface, and the accurate fire can be displayed on the display. Geographical and address information of the place where the alarm occurred. At the same time, the centralized control panel of the fire cannon automatically starts the fire cannon at the corresponding position. After the horizontal and vertical scanning detection mechanism on the fire cannon is used to search and locate the fire source, the water pump is started and the electric valve is opened , The fire water cannon sprayed to extinguish the fire, and after the ignition source was extinguished, the initial state was restored. During the entire search, positioning and fire extinguishing process, the video recorder automatically performs full-time real-time video recording.
