Installation
Installation under the guidance of professionals, and do not install or replace parts without authorization.
During transportation and installation, handle with care to avoid collision damage.
The installed foundation should be able to withstand the load of the fire monitor infrastructure due to unstable factors such as jet reaction force and wind disaster.
Fire monitors should be installed in the upwind direction of the protected place where the wind prevails all the year round.
The pipeline must be flushed before the fire monitor is installed to prevent debris from entering the fire monitor to block the nozzle.
After installation, the nozzle should face the object of protection, and should not face the position of the operator at any time.
The bottom of the control cabinet of the electric and hydraulic fire monitors should be installed indoors, and should be set in a position where each turret can be directly observed. When necessary, the fire control room should be equipped with monitors and other auxiliary observation equipment.
The fire control room should have good fireproof, dustproof and waterproof measures, and the layout of the system control device should be easy to operate and maintain.
Operation
Step 1. In the event of a fire, immediately start the fire pump set of the fire monitor system.
Step 2. The operator holds the fire monitor operating level handle (hand-wheeled fire monitor, holding the operating hand wheel for adjusting the pitch angle), and slowly opens the fire monitor inlet valve.
Step 3. Loosen the positioning and lock device, use the level handle of fire monitor (hand-wheeled fire monitor, use hand wheel to control,) adjust the working angle and rotation, so that the water can fully cover the burning material.
Step 4. When fire monitor is adjusted to the proper position, the level handle of the water gun can lock the positioning and locking handle for directional injection.
Step 5. After using, turn off the system fire pump set.
Step 6. Tilt the nozzle to pour out the remaining liquid in the cavity, then put it in right position, lock the positioning and lock device.
Step 7. Close the inlet valve of fire monitor and check all parts which should be no damage.
